Welcome to Lat 26°®
Carbon Guard™
Carbon Guard™

Carbon Guard™

Carbon Guard™ is a powerful polymer-based synthetic wax designed to seal and protect finishes from black streaks, engine exhaust, industrial fallout, acid rain and UV rays. It seals and protects paint, gel coat, hypalon, rubber as well as hard plastic surfaces. May be used independently or on top of Lat 26˚ UV Protect for the ultimate protection.

Carbon Guard™ is recommended to use on White Paint, as well as, Exhaust & Black Streak Areas


Apply sealant to a clean, polished and well-prepared surface. Use a small amount on a foam applicator and wipe until surface is thoroughly covered then wipe off excess with a clean microfiber towel. This product can also be applied using a Random Orbital with a Lat 26˚ Black Sealing Pad or with another soft foam sealing pad. Product becomes fully cured in 24 hours but can get wet within an hour however for best results wait 8 hours before getting surface wet.


Water (7732-18-5); Polydimethylsiloxane (63148-62-9); Methyl Alcohol (000067561); Decamethylcyclopentasiloxane (00541026); Aminosiloxane; Acrylic Polymer (00009003-01-4); Benzyl Salicylate (118-58-1); Synthetic Isoparaffinic Hydrocarbon (64762-47-8)


Keep this product and all chemicals away from skin and eye contact. KEEP AWAY FROM REACH OF CHILDREN.


In case of ingestion: call your physician immediately refer to MSDS sheet. In case of eye contact: flush eye immediately with water for 20 minutes. Skin contact: flush skin with soap and water. If irritation continues call your physician. Swallowing: can cause nausea, vomiting and diarrhea. Can be fatal. Do not induce vomiting. Drink two glasses of milk. Seek medical attention immediately.


Read and follow directions carefully. More detailed information on this product can be found at www.lat26degrees.com. Lat 26˚ is not responsible for inappropriate use of this product. It is unlawful to use this product in a manner inconsistent with the instructions given on the label.